On Mon, Feb 18, 2019 at 11:02 AM Zebediah Figura <z.figura12@gmail.com> wrote:

On 2/17/19 11:30 PM, Isira Seneviratne wrote:
>
>
> On Mon, Feb 18, 2019 at 10:50 AM Zebediah Figura <z.figura12@gmail.com
> <mailto:z.figura12@gmail.com>> wrote:
>
>�� �� ��On 2/17/19 11:17 PM, Isira Seneviratne wrote:
>�� �� �� >
>�� �� �� > On Mon, Feb 18, 2019 at 9:08 AM Zebediah Figura
>�� �� ��<z.figura12@gmail.com <mailto:z.figura12@gmail.com>
>�� �� �� > <mailto:z.figura12@gmail.com <mailto:z.figura12@gmail.com>>> wrote:
>�� �� �� >
>�� �� �� >
>�� �� �� >
>�� �� �� >�� �� ��On 2/13/19 2:57 AM, Isira Seneviratne wrote:
>�� �� �� >�� �� �� >
>�� �� �� >�� �� �� >
>�� �� �� >�� �� �� >
>�� �� �� >
>�� �� �� >�� �� ��Again, I'm seeing multiple lines show up per test run,
>�� �� �� >
>�� �� �� > Do the tests normally print multiple sets of results? If so, then
>�� �� ��should
>�� �� �� > any of them be ignored?
>�� �� �� >
>�� �� �� >
>
>�� �� ��No, only one set of results is printed per test. You can check this by
>�� �� ��running winetest normally with the -o option, and examining what
>�� �� ��data is
>�� �� ��printed.
>
>
> In that case, I think that something is probably wrong with the winetest
> output, since I'm reading data from the same file that winetest is
> writing data to, with these lines:
>
> SetFilePointer (out_file, -sizeof(buffer), NULL, FILE_CURRENT);
> ReadFile (out_file, buffer, sizeof(buffer), &read_count, NULL);
>
>

Something is probably wrong with the way you're reading from it.

Okay, I'll check my code. Thank you for the feedback.

I'll get back to you in a few hours.