I am playing with Worms II and the installer that comes with the Demo and uncovered a signal handling fault Under Solaris and some wierdness in the installer.
After decompressing the application the installer executes the setup program which displays a splash screen the application then generates a Page Fault Exception. I can't give a stack trace because here is where the wierdness is. The Setup Program seems to not inherit the -debugmsg status and doesn't end up under control of the debugger (By this time there are 5 wine processes running)
Anyway to cut a long story short the page fault DOES occur in a mapped region (Its in VIRTUAL_DumpViews() listing) but doesn't have a handler associated with it. This makes VirtualHandleFault fall through to the following code
BYTE vprot = view->prot[((char *)addr - (char *)view->base) >> page_shift]; void *page = (void *)((UINT_PTR)addr & ~page_mask); char *stack = (char *)NtCurrentTeb()->stack_base + SIGNAL_STACK_SIZE + page_mask + 1; if (vprot & VPROT_GUARD) { VIRTUAL_SetProt( view, page, page_mask + 1, vprot & ~VPROT_GUARD ); ret = STATUS_GUARD_PAGE_VIOLATION; } /* is it inside the stack guard pages? */ if (((char *)addr >= stack) && ((char *)addr < stack + 2*(page_mask+1))) ret = STATUS_STACK_OVERFLOW;
But of course this code doesn't reset the page protections to allow the access.
I Doctored this code so it would always allow the access and the installer then completed OK, But worms itself will not run yet
Q. Should all views have handlers ? Under What Conditions would they not ???