[PATCH 3/4] dinput: Write PID_USAGE_PARAMETER_BLOCK_OFFSET in the set condition report.

[Rémi Bernon]

From: Ivo Ivanov

Required by the PID spec for devices with device managed blocks.

Signed-off-by: Ivo Ivanov 
Signed-off-by: Rémi Bernon 
---
 dlls/dinput/joystick_hid.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/dlls/dinput/joystick_hid.c b/dlls/dinput/joystick_hid.c
index 9968da7d897..a43a73fff17 100644
--- a/dlls/dinput/joystick_hid.c
+++ b/dlls/dinput/joystick_hid.c
@@ -2748,6 +2748,10 @@ static HRESULT WINAPI hid_joystick_effect_Download( IDirectInputEffect *iface )
         case PID_USAGE_ET_FRICTION:
             for (i = 0; i < impl->params.cbTypeSpecificParams / sizeof(DICONDITION); ++i)
             {
+                status = HidP_SetUsageValue( HidP_Output, HID_USAGE_PAGE_PID, 0, PID_USAGE_PARAMETER_BLOCK_OFFSET,
+                                             i, impl->joystick->preparsed, impl->type_specific_buf, report_len );
+                if (status != HIDP_STATUS_SUCCESS) WARN( "HidP_SetUsageValue %04x:%04x returned %#x\n",
+                                                         HID_USAGE_PAGE_PID, PID_USAGE_PARAMETER_BLOCK_OFFSET, status );
                 set_parameter_value( impl, impl->type_specific_buf, set_condition->center_point_offset_caps,
                                      impl->condition[i].lOffset );
                 set_parameter_value( impl, impl->type_specific_buf, set_condition->positive_coefficient_caps,